Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Replacing Lower Ball joints on '93 240 200 1993

posted by  USMA on  Sun Aug 1 09:07 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Sep 3 13:50 CST 2014
[RELATED]

Removed the 4 12 mm bolts holding the top ball joint plate to the Strut tube. Then removed the 3 large (19mm nuts) from the ball joint to A frame. The front bolt was removed and the two bolts closest to the wheel left in place. The assembly did not come apart. Is there any tricks to release top ball joint plate from the strut tube? I was looking in the FAQ section for the instructions and was unable to find any details. Did I miss it?

Roger






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacing Lower Ball joints on '93 240 [200][1993]
posted by  USMA  on Sun Aug 1 09:07 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.