Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2002 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Reinstalling control arm with new bushings and ball joints 900

posted by  sasjzl on  Wed Sep 8 12:44 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 3 17:24 CST 2014
[RELATED]

Hope all is well for everyone.

I am re-installing my control arms with new bushings and ball joints and wanting to know if anyone has any famous last words. I had the bushings installed by my local indy and am just bolting it up. I know that there is some point at which I need to lower it down on to my wheel ramps to put pressure in the right place. What I am wondering is what should I leave untightened. Al three of the attachment points, front, rear bushings and ball joints? I have done some due diligence searching and have not seen anything specifically on this.

Thanks very much,
Jim Lee






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Reinstalling control arm with new bushings and ball joints [900]
posted by  sasjzl  on Wed Sep 8 12:44 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.