Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Changing front pads: Bendix ABS 700 1988

posted by  rstarkie on  Sun Dec 5 03:45 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:14 CST 2014
[RELATED]

I have only changed pads on a Bendix equipped car once. It was four or five years ago and I remember it gave me a difficult time.

Can you leave the caliper in place and simply remove the long bolt that secures the bracket at the bottom and then pivot it upwards to remove and install the pads. I use the word "bracket" to describe the piece that is held on by the two cleaned and greased pins approximately 5/16" diameter.

My previous experience had me removing the caliper assembly, inserting the pads, and then replacing the loaded caliper before bolting it in place with the two hex head fastners. My failing memory tells me that removing the one bracket bolt did not allow the bracket to pivot up and allow access to the pads with the caliper in place.

What is your experience, please?

Randy






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Changing front pads: Bendix ABS [700][1988]
posted by  rstarkie subscriber  on Sun Dec 5 03:45 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.