Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

fuel rail leaking fuel from bottom of main tube approx. 5/8" diameter 200 1993

posted by  1fatcat on  Fri Jan 14 18:02 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 7 14:13 CST 2011
[RELATED]

I located a used one off a '92 I have '93 but they look the same Ebay $60.00 complete with injectors. I was thinking of removing my rail and cleaning this simple steel tube up and use some J B weld to seal the 3 pin holes that are in bottom of steel tube. Is this asking for trouble? Of would soldering it up work better, braze? I'm quite skilled with a torch. I don't know if this is just a dumb move or normal for such a thing. SPEND THE $60.00 AND BE DONE WITH IT,
THE STEALER WANTS $170.00 FOR NAKED RAIL. BTW by simply wiring up the oxygen sensor, my #4 fuse energizes momentarily when I turn key on, fired right off once new filter filled up.

I went to close rear hatch and now it no longer latches. Is this a mechanism similar to doors, I tried key both ways and the lever inside and the child proof switch, no latch. Fix one matter two pop up, WTF?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New fuel rail leaking fuel from bottom of main tube approx. 5/8&quot; diameter [200][1993]
posted by  1fatcat  on Fri Jan 14 18:02 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.