Volvo RWD 1800 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2012 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1800S Wheel Puller 1800

posted by  SalvageHunter on  Sat Jan 29 09:36 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Feb 1 16:44 CST 2011
[RELATED]

I restored a Volvo 1800S several years back and experienced difficulty removing the rear brake drums. I have a 3-legged puller that did not adapt very well. Hence, I built my own and it is now for sale as I have no further use for it. It could be adapted rather easily to other drums or hubs.

The puller was made specifically for a Volvo 1800S and worked extremely well, much better than a standard 3-legged puller. It was made by an Oak Ridge machinist using a Buick brake rotor and a few miscellaneous parts from my inventory. Go to website www.SalvageHunter.com for pictures and perhaps a better description. I am currently experiencing problems uploading pictures. I can, however, send pictures via email if requested.

Thanks.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1800S Wheel Puller [1800]
posted by  SalvageHunter  on Sat Jan 29 09:36 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.