Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2001 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

940 wagon rear spring spacer with HD spring 900 1994

posted by  percussionist on  Tue May 3 21:00 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue May 27 19:20 CST 2014
[RELATED]

Replacing the rear springs on my 94 945 with Scan Tech HD springs from FCP. The spacer (rubber part that sits on top of spring) does not want to fit into the larger diameter coil. I think that I can get it to fit by doing some careful cutting and shaping of the spacer so that it fits snug and will allow the spring anchor (cup shaped metal washer that bolts under the top of the spring to hold it in place. Will that hurt, so long as the assembly bolts up, and the spring sits in the bottom rubber spacer? Is the "stop" (piece of the spacer that butts against the end of the coil) necessary?
Thanks!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 940 wagon rear spring spacer with HD spring [900][1994]
posted by  percussionist  on Tue May 3 21:00 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.