Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Oxygen Sensor Error Code & Trouble Shooting 200 1992

posted by  Dan Marino on  Tue Oct 11 08:10 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:46 CST 2014
[RELATED]

Back in April I installed a new oxygen sensor (Bosch I think) in my 240 wagon. The car is now throwing a check engine light with trouble code 2-1-2 for a faulty oxygen sensor.

Any ideas on trouble shooting this?

So far I've looked at the wires leaving the sensor and all 3 look good there.
Under the hood at the firewall the two wires from the sensor go to a harness and seem fine. Then the 3rd wire (ground wire I think) plugs into another harness connection. Again it looks fine.

I tried to check for continuity on the ground wire, but I can't seem to complete the circuit. I took my meter and went from the sensor wire to a ground point with no continity. I then went from the wire harness to a ground point and got no continuity. Am I doing something wrong?

So how do I trouble shoot this issue going forward?

Thanks,

Tom






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Oxygen Sensor Error Code & Trouble Shooting [200][1992]
posted by  Dan Marino  on Tue Oct 11 08:10 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.