Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

screws to attach Ignition Control Module to heat sink... 200 1989

posted by  jomarex on  Mon Oct 31 15:15 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Aug 5 11:56 CST 2014
[RELATED]

There was some teenager out there messin' with this car, ya know, and it musta been him that cross-threaded the ICM screws...

The screws attaching the ICM to the heat sink are pretty darn soft, so I'm assuming they are part of the heat transfer? The hardware store guy doesn't know anything about it. What kind of metal are these screws made of, and what'll happen if I put regular steel ones in there? Or I guess some dissimilar-metal-corrosion could happen...






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New screws to attach Ignition Control Module to heat sink... [200][1989]
posted by  jomarex subscriber  on Mon Oct 31 15:15 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.