Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2019 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

swapping out hub and shaft assembly - rear axle 200 1983

83 245 M46 -All rear bushings have been replaced except the track rod bushings. New springs and shocks. New U-joints on the driveshaft. All engine/trans mounts are good.

I've been reading the archives about this knock and play sound in my rear axle on take off or when applying the gas after coasting. After putting the rear of the car on jacks and turning the wheels I can tell that its got something to do with the rear axle. I don't seem to get the play in the wheel like you would on the front. I can't move them when checking play at 12/6 or 3/9. When I turn the rear drivers wheel it sounds not right with the wheel in the air.

Can a rear wheel bearing cause a knocking sound with the feeling of some play at take off?

Can I just swap out the hub from a parts car with the same rear axle. I'm certain the 86 parts car has the same axle. Does the hub have the bearing contained inside of it. Can I swap hubs without replacing the bearings? Looking for a quick way with minimal cost to see if the bearings are the issue or if the rear axle is going to need replacing.

Thanks








THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 swapping out hub and shaft assembly - rear axle [200][1983]
posted by  transit wind subscriber  on Wed Dec 7 14:35 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.