Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

is "No-OX' good for connectors? 200 1993

posted by  flood on  Wed Mar 7 16:16 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:07 CST 2014
[RELATED]

I have been trying to solve an engine temp sensor issue, replaced the sensor (did not use sealing tape) tested good on the bench, bad in the car as tested from the ECU. The connector plug appears to be trauma free, but some green corrosion can be seen. Should I try to work some electician's "no-ox" paste into the connector? If not, any other suggestions?
thanks in advance






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ANSWERED is &quot;No-OX' good for connectors? [200][1993]
posted by  flood subscriber  on Wed Mar 7 16:16 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.