Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

getting the S10 2.5L ready for my PV544 444-544

posted by  rayjanj on  Fri May 18 15:44 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 07:24 CST 2014
[RELATED]

Hello,

I have finally started assembly of my S10 2.5L engine. I have it adapted to a Toyota Supra W58 5 speed using all stock parts so far. I went this route as the Toyota trans in narrower than the S10 T5. It uses a stock Jeep bellhousing which has the GM bolt pattern and the Toyota trans pattern and the same starter pocket location. Tomorrow is clutch and clutch linkage day.

I live in Arkansas and the car is in the body shop in Indiana. It should be ready for transport home the first week of June so I am trying to get the engine ready to install as soon as it gets here.

Best to all.

Ray J.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New getting the S10 2.5L ready for my PV544 [444-544]
posted by  rayjanj subscriber  on Fri May 18 15:44 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.