Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Fried gauges and what else? LH3.1/572 200

Sooo... I got a new set of gauges for my '90 240... I got so excited to install them I failed to take care and read any installation tips... I didn't disconnect the ground at the battery. I pulled the old gauges, installed the new ones... Pulled the big old broken clock and put in a tach from an '82 turbo.. The only wires I know I plugged in correctly were the full round and half-round plugs. I'm pretty sure I plugged the red/white into the base of the tach, one of the three prongs at the top of the tach, the double (cruise control) prongs next to the speedo etc... I understand I fried everything gauge related... I drove without gauges functioning for about a week... some component of the charging system stop function and the battery was drained... I had an extra new battery and new alternator in my shop, so I swapped those in. repeated the debotchery of the first half of this post and now have irregular charging showing on my 52mm volt gauge... sometimes 11 volts, sometimes it pops up to 13.5...

What have I done?

Thanks in advance for any insight.

- Michael






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Fried gauges and what else? LH3.1/572 [200]
posted by  Vonheck  on Thu Aug 2 20:30 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.