Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Putting It back together - cam shaft seals (I think) 900 1994

posted by  rparkerm on  Fri Oct 26 17:03 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Dec 16 17:33 CST 2013
[RELATED]

OK, so I was nutty enough to undertake replacing the head gasket due to oil leaking into the coolant.

I did get to buy lots of new tools :)

I am putting it back together and wondering about camshaft seals. Is there on in the back (under the distributor)? I am going to try for pictures here, but not sure I can get them to load.

They are under the technical pictures section. I have a pic of the front of the camshaft where I think the orange rubber seal goes. Does it go with the U opening facing into the head (so the steel spring is no longer visible)? (OK, is that actually a camshaft seal to begin with?)

I am hoping there is not supposed to be a seal in the back end where it would be visible if you take the distributor off.

Thanks







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Putting It back together - cam shaft seals (I think) [900][1994]
posted by  rparkerm  on Fri Oct 26 17:03 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.