Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2014 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

240 front suspension woes- lEFT FRONT SITTING HIGH 200 1990

posted by  sonoma240 on  Sat Jan 5 17:29 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jan 8 15:10 CST 2013
[RELATED]

Just replaced driver side only ball joint,and sway bar links both sides. Driver side is now about two inches higher. Tried bouncing on bumper, no effect.

Ball joint to control arm bolts snug and torqued. Tie rod end tight.

I did have to disconnect outer tie rod and sway link in order swing out the strut a bit to get to broken ball joint to strut tower bolts.

Those bolts still broken. Tried drilling and using bolt extractor two days in a row-getting nowhere. Attached balljoint with 2 new M8 30 1.25 hardened bolts.

I don't see and separation at plate, know that I need all 4 bolts for safety. I can't see to get them and local shops quoted between $160-400 to extract 2 bolts.

Don't understand what I could have done to cause the "over extension". Archives no help in this case. Any guidance appreciated.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 front suspension woes- lEFT FRONT SITTING HIGH [200][1990]
posted by  sonoma240 subscriber  on Sat Jan 5 17:29 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.