Volvo RWD 120-130 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2007 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Which is the right side for rods to be connected to the pistons? 120-130

posted by  DBS on  Mon Mar 18 20:30 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 19:33 CST 2014
[RELATED]

I got the block back, bored to 030! All looks good. I also got the rods back with the pin bearings installed.


It was when I was going to connect the rods to the pistons that I realized I didn't make note of which was the right side.

The numbers stamped on the side of the rods (on the arm and on the cap) to denote which cylinder it goes in...should it be facing the oil filter side? Or doesn't it really matter?

Please advise. Thanks in advance, hombres!

-DS






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Which is the right side for rods to be connected to the pistons? [120-130]
posted by  DBS  on Mon Mar 18 20:30 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.