Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/1998 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Mechanical pressure gauge install on 1983 242 200 1983

posted by  sedan delivery on  Tue Jul 23 23:42 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jun 15 18:52 CST 2014
[RELATED]

I may have a low oil pressure issue with my 1983 242. The gauge reads 2 bars of pressure on a 5 bar gauge at start up. With a hot engine at idle the pressure reads less than 1 bar and the oil light comes on. Cold engine or hot at 1200 RPM or above the gauge reads between 2.5 and 3 bars. I have been told on the forums to test the pressure with a mechanical test gauge. Is it better to purchase a mechanical test gauge to test for a bad oil sending unit or install a permanent mechanical oil pressure gauge on the dash.


--
1983 242 GLT / 1991 244 / 1993 245 / 1999 v70






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Mechanical pressure gauge install on 1983 242 [200][1983]
posted by  sedan delivery  on Tue Jul 23 23:42 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.