Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2018 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Bad Vibrations part 2 200

Last week I complained about a shudder from a standing start to about 35 MPH. The u-joints feel tight. At the center carrier bearing rubber donut there is very little play. I noticed when I turned the tires the rear ended "rolled" forward quite a bit. I traced it to the torque arm bushings. Three of them are very loose. The fourth has left town. There is nothing left. Could this be the source of the shudder or should I keep looking? Thanks again!
--
Bob, SC, 1965 PV544, 1988 240 wagon






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Bad Vibrations part 2 [200]
posted by  bluePV544 subscriber  on Sat Aug 17 16:44 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.