Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

92 240 CHECK ENGINE LIGHT/NEW DOWNPIPE 200 1992

posted by  jeffmaciejewski on  Sat Aug 24 14:54 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Apr 22 08:12 CST 2014
[RELATED]

Hi all--

I just installed a new down pipe and am now getting a check engine light. I retrieved the codes and they're 1-1-3 (fuel injectors) and 2-3-2 (Lambda adjustment). I have noticed the engine to be running a little rough at idle. I had no check engine light before replacing the down pipe.

During the installation of the down pipe, I tried to be careful to not interfere with the O2 sensor (on mine it is installed directly into the catalytic converter--I have an aftermarket IPD cat). But since I had to shear off the old mounting bolts between the old downpipe and the cat (using an angle grinder) I'm thinking that some debris might have fouled the sensor and is causing the rough idle and is causing the check engine light.

Problem is, new O2 sensors ain't cheap--so I want to be reasonably sure about the diagnosis before I make the plunge and buy a new O2 sensor in an effort to correct the system.

Any thoughts about this diagnosis of the check engine light?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 92 240 CHECK ENGINE LIGHT/NEW DOWNPIPE [200][1992]
posted by  jeffmaciejewski  on Sat Aug 24 14:54 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.