Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine noisy, rubber mounts too hard ? 200 1982

posted by  Rolandp on  Fri Nov 29 19:35 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 15 17:36 CST 2014
[RELATED]

I had a clutch disk kit installed lately. At the same time I supplied 2 new engine rubber mounts (not Volvo brand) and the one for the transmission in case there was problems.

The right side engine mount was replaced. I find I hear more engine vibration noise since the clutch was fixed. I checked all the exaust system and found no leak or anything wrong.

Now I am wondering if harder rubber mounts is the problem. I also have a 1991 to compare with. That engine noise transfer to the inside is not acceptable.

The rubber mount for the transmission is a Febi Bilstein and is much softer than the engine left side which is Uro brand.

Do you suggest I have to go to Volvo brand ?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine noisy, rubber mounts too hard ? [200][1982]
posted by  Rolandp  on Fri Nov 29 19:35 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.