Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Torque rod removal/install -- 240s 200

posted by  Adirondack Blues on  Fri Dec 6 17:31 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Sep 8 12:11 CST 2014
[RELATED]

In the past, I have removed and replaced torque rods successfully using ramps. I did one side at a time. Was I just lucky? Reading some of the posts, it seems people think the axle should be able to hang free, or alignment problems can occur with the bolts.

Just wondering before I try to get lucky again.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Torque rod removal/install -- 240s [200]
posted by  Adirondack Blues  on Fri Dec 6 17:31 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.