Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

89 244, need help, problems continue 200

uid 27016's pic
posted by  Mech65 on  Mon Jan 13 11:06 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 09:24 CST 2014
[RELATED]

My problem has been going on for some time. It is getting progressively worse.

I have changed/replaced.
AMM (new)
Temp sensor
Plugs/cap and router and wires
fuel pump relay
Fuel regulator
Transfer pump
throttle switch
Knock sensor
Coil
Ignition control modual...behind battery
harmonic balancer ( just because to was cracking and looked bad)
wires at Gray connector look good.


While checking my timing I noticed the light would skip a beat every once and a while. I checked incoming voltage at the coil and it cuts out momentarily at random times.

In the Bently they talk about taking the ICU plug backshell apart and checking voltage. I can't see how it comes apart.



My question is, go after the ignition control unit under the dash or something else?

Pulling my dang hair out....

Anybody else have/had this issue?

Thanks
Trevin
--
89 244






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 89 244, need help, problems continue [200]
posted by  Mech65  on Mon Jan 13 11:06 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.