Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2006

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

91 240 CEL Light On After HG Change

posted by  Dellaone on  Sat Apr 5 18:04 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Aug 15 19:30 CST 2014
[RELATED]

I replaced my 1991 240 sedan head gasket due to oil leakage, (marking it's spot was an understatement). After replacement, the CEL was on. I retrieved a 411 code (throttle position sensor). I purchased a new, same part number sensor, but I am unable to clear the code, and I am beginning to suspect the plug or wiring. The Haynes manual appears to be useless for this. Does anyone have a good diagram or suggestions on troubleshooting this problem? The engine itself still runs great, just like it had before, so I know there must be an open or other wiring anomaly.

Thanks for any insight!

Dave






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 91 240 CEL Light On After HG Change
posted by  Dellaone  on Sat Apr 5 18:04 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.