Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

My first Head Gasket job - questions about machine shops and other things 200 1989

posted by  CineMan on  Thu Apr 17 13:17 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Sep 30 15:21 CST 2014
[RELATED]

Hello fellow brick lovers. I'm doing my first head gasket job and actually having a good time, but I have some questions. Mainly I don't want to take my head into a machine shop and seem like a total fool who is easily taken advantage of.

I have a full Elring Head Gasket Set and I find it frustrating that I can't find an itemized list of its contents. Are there seals or o-rings in there that I need to put in the head myself, and should I do that before it goes to the shop? For instance the front and rear camshaft seals, should I take those with me to the machine shop and have them install them? Is it normal for the shop to provide all the necessary parts required as part of the job? I want to have them do a valve job too, do they usually provide any needed parts there as well?

Are there things I should check for/do in the block since I am this deep into the engine?


Thanks,
Ryan






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New My first Head Gasket job - questions about machine shops and other things [200][1989]
posted by  CineMan  on Thu Apr 17 13:17 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.