Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2006 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

1989 Volvo Sedan B230f EZ116k engine_won't keep running 700

My OBD codes pop-up with 2-1-4 continuously (RPM sensor signal missing intermittently or no signal). Replaced RPM sensor three times,still the code persists. I have changed the plugs, wires, distributor & peripherals.

The engine starts but won't idle and at high RPM's misses intermittently. The engine burns very rich, and at times will back fire into the intake. Changed both fuel pumps, relay works fine. ETC is new and works. I don't think it's the FI module since the engine does start. All the vacuum hoses have been replaced.
I replaced the injectors also. I don't see any fuel in the oil. Coil is good, and with a noid light the injectors show consistent electrical power.


Been working on this issue for several months now and am at a point where I have done everything except tear the engine down to the bare block.
.
So send me any and all feedback on this issue please.
--
89-740 GLE_91-940 Sedan _98-V90 Wagon_2001Mazda626






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1989 Volvo Sedan B230f EZ116k engine_won't keep running [700]
posted by  volvosenior subscriber  on Mon Aug 11 22:00 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.