Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2009 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

1989 - 740 GL Sedan -suspension query 700

posted by  volvosenior on  Sun Aug 17 23:35 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 21 21:49 CST 2014
[RELATED]

Sway Bar End Links. "[Editor] Note that the rubber bushings in your sway barPhoto courtesy of IPD end links will crack and wear. It makes more sense to replace the entire link, due to likely corrosion, than just the bushings. Note that there are two styles when ordering: the photo from IPD illustrates the differences between the early 4-piece link for steel control arms and the later 8-piece link for aluminum control arms.


When installing the new bushings, tighten the nuts so that the distance between the top and bottom of the outer washers (the surface next to the nuts) is 42mm."

I am not clear on this measurement. 42 mm is 1.65 in. but measured from what points?outer washers? there are four of them.....???
--
89-740 GLE_91-940 Sedan _98-V90 Wagon_2001Mazda626






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1989 - 740 GL Sedan -suspension query [700]
posted by  volvosenior subscriber  on Sun Aug 17 23:35 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.