Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replace banjo fitting at fuel filter - how? 200 1990

posted by  jon_h on  Thu Oct 30 21:36 CST 2014
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 11:57 CST 2014
[RELATED]

Found a perforated banjo fitting on the output end of the fuel filter. I have some good used ones. I read threads here about replacing. Didn't find any that discussed inserting the replacement fitting into the old line.

This is a heat-shrink fit into a nylon hose. As the hose will have gas liquid, vapors, and varnish, heating the line to soften it is infeasible.

I called a friend who makes hose fr a living. She said that the line would be brittle after 20+ years so heating it probably wouldn't work anyway.

Has anyone put a new/used fitting into an old line - if so, how?

(I took a banjo fitting with a 6" piece and attached it to the existing like using a short piece of fuel line and clamps.)
--
240 drivers / parts cars - JH, Ohio






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replace banjo fitting at fuel filter - how? [200][1990]
posted by  jon_h  on Thu Oct 30 21:36 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.