Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Tranny install guidance 200 1984

posted by  Dick Slessig on  Sun Feb 14 09:10 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 15:14 CST 2014
[RELATED]

Hello All

I'm in the midst of installing a new old M46 in my "84 245, and I'm having a hell of a time acheiving final insertion. I'm over the hump with the starter housing and I'm within an inch or less of where it needs to be.
New clutch was aligned with a proper alignment tool before I commenced this phase, but I'm wondering if I knocked it out of alignment and need to back out and start again (nighmare), of just keep finagling until it finally meshes.

Or is there some trick I'm missing? Motor mounts are loosened and right side of engine is presently raised.

Thanks as always






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tranny install guidance [200][1984]
posted by  Dick Slessig  on Sun Feb 14 09:10 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.