Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Crankshaft Bolt removal after belts removed 200 1983

posted by  NewMexico240 on  Mon Mar 28 17:46 CST 2016
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 11:52 CST 2014
[RELATED]

Job: water pump, timing belt, and three seals.

I didn't realize that the volvo tool to hold the crankshaft pully is not designed for the B23. I have already loosened the other two pully's and all belts are off.

I just read up on using the breakerbar on the bolt while touching on the starter to loosen the bolt.

How could the rope trick help at this time?

What would you do at this point?

No impact wrench available.

I now realize that I should have loosened the Crankshaft bolt before anything else was touched.

Thanks in advance.
Joseph in New Mexico





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Crankshaft Bolt removal after belts removed [200][1983]
posted by  NewMexico240 subscriber  on Mon Mar 28 17:46 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.