Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

flex plates - 240 motor installed in a 940 200 1990

posted by  jon_h on  Fri Mar 24 11:09 CST 2017
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 11:57 CST 2014
[RELATED]

Put a 240 motor into a 940. Hadn't seen a 940 flex plate but heard it was different from the 89-up 240 flex plates.

940 plate at top; 240 plate below. markings are basically the same ie. there's an arrow on the back (engine-block side) that lines up with the CPS.

The 940 plate also had the 2 pins (on the engine-block side) in the same position as the 240 pins. They are not marked with cutouts on the 940 as they are on the 240.
--
240 drivers / parts cars - JH, Ohio







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New flex plates - 240 motor installed in a 940 [200][1990]
posted by  jon_h  on Fri Mar 24 11:09 CST 2017 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.