Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2017 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1993 - 240 Valve Hushers - Should I Cheap out? 200

posted by  RicoS on  Tue Sep 17 11:40 CST 2019
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 02:18 CST 2014
[RELATED]

I'm about to R&R the Timing Belt on a 1993 240. The last time I did one, I also replaced the Camshaft Follower Dampers (aka, Valve Hushers).

At that time I used Volvo OE Hushers, but I notice I can get aftermarket Hushers ( Branded Victor Reinz) from FCP for 47 cents a pop while the Volvo Hushers are $3.58 apiece.

So, has anyone used these bargain basement Hushers without complaint?

Both the OE and the Reinz parts are listed as "made in Italy", if that means anything.

I look for bargains, but I also consider equivalency. For example, I have a stockpile of Volvo OE Rear Crank Seals because I was buying the cheaper Elring seals until they started coming from China. Those seemed to be of such a high durometer I couldn't bring myself to use them - used only OE Volvo after that.

Any input will be appreciated.

Thanks, one and all,
Rich (from The Burgh)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1993 - 240 Valve Hushers - Should I Cheap out? [200]
posted by  RicoS  on Tue Sep 17 11:40 CST 2019 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.