Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Transmission cooling pipe repair by brazing/soldering 200

posted by  volvo240student on  Fri Feb 28 20:28 CST 2020
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Hello,

One of my aluminum/steel automatic transmission pipe part number 1306839 on my Volvo 240 1993 has developed pin hole leak where the bottom clamp is holding the both pipes. Combination of tight clamp and shaking has created pin hole. I am thinking of soldering/blazing it instead of replacing the whole pipe. Did some of you tried similar ? I have only solder plumbing copper pipes so I dont know if that is possible or how strong the seal will be.

Thanks!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Transmission cooling pipe repair by brazing/soldering [200]
posted by  volvo240student  on Fri Feb 28 20:28 CST 2020 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.