Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2006

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Cutting a u-joint when the bearing cap went through the wrong side

posted by  Will740turbo on  Sun Jun 19 22:45 CST 2022
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 16:09 CST 2014
[RELATED]

1990 740

I herped when I should have derped and ended up pushing a new u-joint's bearing cap alllll the way through. Now I can't get the cap back out the way it came and I can't get the cross out of the yoke.

What's the easiest part of the u-joint to cut? The polished surface where the bearings ride, or closer to the center? These are non-greasable (read: sealed) u-joints, so the center is not hollow.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Cutting a u-joint when the bearing cap went through the wrong side
posted by  Will740turbo subscriber  on Sun Jun 19 22:45 CST 2022 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.