Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

egr system 200 1989

posted by  greencastle on  Wed Nov 15 20:37 CST 2023
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I have recently disabled the EGR on my 240. I had a non EGR exhaust manifold which I installed, leaving all the hardware on board. I sealed the intake manifold fitting with a homemade gasket. Gas mileage increased slightly.I still need to remove the vacuum from the EGR valve. The vacuum line appears to end at a device near the coil on left side. There are 2 small vacuum lines attached to what I think is called a vacuum solenoid. Part nbr. printed on the device is 4996. Can I remove the vacuum line here? Do I need to do anything else to complete my EGR project?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New egr system [200][1989]
posted by  greencastle  on Wed Nov 15 20:37 CST 2023 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.