Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2015 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Which wire when prelubing engine 900 1994

posted by  someone claiming to be greg nottingham on  Wed Nov 1 09:38 CST 2000 [RELATED]

Depending if I am prelubing the turbo or doing a compression test, the service manuals say to remove terminal #1 wire or terminal #15 wire from the ignition coil.

If I am prelubing after an oil change which takes about 15 seconds for the light to go out, should I disconnect the coil wire and one of the above named wires or is it sufficient just to remove one of the terminal wires?

Thanks,

Greg





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Which wire when prelubing engine [900][1994]
posted by  someone claiming to be greg nottingham  on Wed Nov 1 09:38 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.