Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Broken Manifold Stud Replacement 200 84

posted by  someone claiming to be Randolph on  Sat Nov 25 02:01 CST 2000 [RELATED]

Brickheads,

I have to replace 4 broken manifold studs in the 84 Turbo project car. I plan to follow the procedure laid out in the FAQ. I'll be using a rt. angle drill (millwaukee)and cobalt bits.

I want to re-tap the holes for a 10mm. stainless allen cap screws.

Is there anything I should be aware of outside of the advice given in the FAQ? I am worried that there might not be enough clearance to drill the studs in the front and back of the head.

Any tips on keeping the holes perpendicular to the head? I don't want to remove the engine if I don't have to.

As always, thanks





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Broken Manifold Stud Replacement [200][84]
posted by  someone claiming to be Randolph  on Sat Nov 25 02:01 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.