Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Brake differential pressure valve 200 1983

posted by  someone claiming to be Justin Bowser on  Sat Dec 30 12:24 CST 2000 [RELATED]

Just finished doing the front brakes on this (new rotors and pads) and flushing/bleeding the hydraulic system. After this little exercise the brake failure lamp will not go out, have good hard pedal so I feel I got out all of the air.

I am assuming there is a piston of some sorts in there that deflects to one side or the other if fluid pressure is not the same on both sides and it got set when I was bleeding.

Is there a way to "reset" this thing? The Haynes manual says to replace but I think unhooking the wires would be easier and cheaper! ;-)

Any suggestions?

Justin Bowser





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Brake differential pressure valve [200][1983]
posted by  someone claiming to be Justin Bowser  on Sat Dec 30 12:24 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.