Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

header pipe to cat converter connection 200 1991

posted by  someone claiming to be jeff on  Tue Jan 30 17:38 CST 2001 [RELATED]

I have a 1991 240 without the EGR system. With my entire exhaust system going to hell in a handbasket I decided to replace everything needing replacement (the manifold and cat were fine). I ordered the parts and things were swell until I tried to connect the new header pipe to my original cat. converter, the bolt patterns to the flanges do not line up between the two. Has anyone seen this before? Did volvo change this so we'd have to purchase a new cat at the same time? Everything else fits I can get more specific if this peaks anyones interest. Thanks for any information.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New header pipe to cat converter connection [200][1991]
posted by  someone claiming to be jeff  on Tue Jan 30 17:38 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.