Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2004 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Separating control arm and tie rod ball joint 900 93

posted by  someone claiming to be Duane C. Skelton on  Sat May 5 14:07 CST 2001 [RELATED]

So I went to change strut inserts and found that I couldn't just knock em out (jently or otherwise) like I could with previous cars. The fork didn't work either. Anyone know where I can get a tool like the one in the Haynes manual. Looks like a mechanical thumb and two fingers with a bolt to tighten the grip? Found something from Matco, but was $75.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Separating control arm and tie rod ball joint [900][93]
posted by  someone claiming to be Duane C. Skelton  on Sat May 5 14:07 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.