Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

tie rod ends/proper install 200 83

posted by  someone claiming to be RR on  Fri May 25 02:07 CST 2001 [RELATED]

Hey guys,

When installing tie rod ends,is it necessary to clamp the underside up into the spindle housing?I did not and I can see some of the rod below the spindle as if I didnt tighten the nut down enough.Would this cause clunking when making short turns?

Thanks

RR





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New tie rod ends/proper install [200][83]
posted by  someone claiming to be RR  on Fri May 25 02:07 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.