Volvo RWD ALL Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2013 ALL INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

upside down drill lube--help? ALL all

posted by  someone claiming to be B D Irish on  Wed May 16 09:35 CST 2001 [RELATED]

I am going to be lying under my vehicle drilling upward into the frame rails; any suggestions on type of lube to use on the drill bit to avoid burning the temper out of it? Cutting oil seems likely to run down faster than I could apply it with one hand while holding the drill with the other. Moly-B grease? some other type of grease applied to the hole site or drill tip? Thanks in advance. (ps-if this were a 1/4" hole, I'd just buy a bunch of cheap bits and not worry about it, but the hole is over 1/2 inch and the bit I'm using is definitely not cheap)





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New upside down drill lube--help? [ALL][all]
posted by  someone claiming to be B D Irish  on Wed May 16 09:35 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.