Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Center support bushing question 200 87

posted by  someone claiming to be Ryan Bennett on  Wed May 16 15:48 CST 2001 [RELATED]

Hello everyone-

My shifter (auto)is really starting to bob around over rough surfaces. I've had it looked at while in the shop for other causes, and it looks like my tranny has two very tiny leaks. One is in the middle (over the tranny support), and the other is the tailshaft. Now that the center support bushing is worn, it's allowing more play in the tailshaft, so it's starting to leak a little more.

Here's my question. The bushing is bad because of normal wear and tear that's been supplemented by fluid leaking on it, weakening it. To fix this leak in the center of the trans. would require rebuilding the transmission according to the mechanic. I don't want to have the transmission rebuilt because everything works fine.

1. Can I wrap the bushing in something to protect it from the fluid?

2. How easy a job is this to do? Can I just unbolt the center support and replace the bushings? How does is work?

Thanks!!!!!





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Center support bushing question [200][87]
posted by  someone claiming to be Ryan Bennett  on Wed May 16 15:48 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.