Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2001 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

REAR BEARING REPEATED FAILURE 700 90

posted by  someone claiming to be Robert S. on  Sat Nov 17 07:14 CST 2001 [RELATED]

I need Your hepl !!!!!!!!!!!

I changed rotors for new ones and replaced rear bearing that was separated and everything was fine for a while.2 months later I started to feel slight pulsation in the braking. Today I discovered that I have axial play in the rear bearing again. I cracked the bearing again. Rear axle has about 0.01 in axial play. I could move the halfshaft in and out by this much. My brakes started to pulsate again.

What is causing bearing separation. Could this be a caliper? Both pistons are moving in when compressed with c-clamp.

Or maybe I have worn out axle housing. It looks like my bearing is beeing held in place by 2 oil seals. One on each side of the bearing unit. Then there is a pressure plate thar compresses whole assembly.

Is anyone aware of any shims that are beeng used to compensate for play?

What is going on?

If I need to change rear axle can I get one with differential lock?

Anyone please HELP !!!!!!!!

Robert





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New REAR BEARING REPEATED FAILURE [700][90]
posted by  someone claiming to be Robert S.  on Sat Nov 17 07:14 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.