Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2000 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: Wiring Harness 200 85

posted by  someone claiming to be Tom Frisardi on  Mon Sep 14 10:15 CST 1998 [RELATED]

Contrary to some other messages I've seen posted on the Brickboard, I changed the wire harness without removing the manifold or the throttle body. I just removed the intake airhose and AMM, plus the crankcase vent hoses and the idle air valve and its hoses. This saves a few dollars on parts, and you don't have to open any fuel lines or deal with intake manifold studs. Good luck.






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.