Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2001 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: O2 Sensor Info 700 1985

posted by  someone claiming to be Don Willson on  Thu Oct 29 14:43 CST 1998 [RELATED]

Disconnect the sensor lead, not the heater leads, and put a digital volt meter on the sensor side. Then lean out the mixture (pull a vacuum hose off) then enrichen the mixture (add propane/butane from a torch into the air stream). The voltage should QUICKLY move from .2 to .8 volts. (I cannot find my tech sheet but it moves in this range but I don's recal which direction. The Bosch part number is 13006 and you should be able to get it from most independent parts house. (I found that the chains such as Auto Zone) are as high at dealers. You will need a deep socket wrench with a slot cut in it so you can slip in on the sensor with the wire attached.






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.