Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: Changing the support bearing and rear transmission seal 200 85

posted by  someone claiming to be Neal on  Thu Jun 3 07:29 CST 1999 [RELATED]

I'd add that if you can get the seal and the bushing out without removing the housing, do it. I did this job about 2 weeks ago ( thanks to the archived message mentioned previously, it was on the money). The job went smoothly until I had to remove the old gasket. It was stuck on the trans and took me HOURS to get that sucker off. You might me luckier.

Neal






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.