Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Gauge Swap- Terminal diagram needed 200 1985

posted by  someone claiming to be Nick Fischer on  Fri Jul 27 12:57 CST 2001 [RELATED]

I just won a Turbo Cluster w/ 120 speedo, Tach, small clock, and Turbo cluster. However, NO wiring was included. So I need to know what the terminals on the back of the tach (the ones for the clock) are (a diagram would be great!) and what terminals are which on the back of the clock (again a diagram would be great) so i can make a harness. Also can i steal a bezel ( the black plastic thing to mount the clock in) from the Turbo cluster (im not sure if the clock has one around it or not)? Maybe from the boost gauge? Your help is greatly appreciated, I may need more help later when i decide to hook up the oil pressure and/or the volt gauge (I'm going to see if i can't fit one in the bottom radio location)(anyone got a oil sender unit cheap?) Once again, Thanks.

Nick Fischer





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Gauge Swap- Terminal diagram needed [200][1985]
posted by  someone claiming to be Nick Fischer  on Fri Jul 27 12:57 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.