Volvo RWD 740-760 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2003 740-760 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

You don't need torque...you need new bearings. 740-760 89

posted by  someone claiming to be johnb on  Thu Jul 23 00:40 CST 1998 [RELATED]

ICQ>

If you can feel flat spots they're toast. Probably dented the races too.

Probably galled/brinneled too.

You can have new races (come with the bearings) installed at the dealer or any shop but I've simply tapped them in with a block of wood and a hammer (knock the old ones out with a brass or pin drift).

Generally, with tapered bearings, you grease them and torque the nut to 25 ft lbs or so while turning the hub and then BACK off the nut to the nearest hole the cotter key fits. Don't forget to use a synthetic high temperature bearing lube and a NEW grease seal on the hub. Clean off the spindle, etc.

However, on ball bearings, it varies. The dealer or a mechanic at an independent shop (could always go to a library or local Auto-Zone or TRAK auto has manuals too) may tell you the torquing procedure.






<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.