Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Can I Move My Oxygen Sensor? 200 1992

posted by  someone claiming to be Bob Mohr on  Sat Nov 6 15:54 CST 1999 [RELATED]

I finally found a muffler shop that's willing to do the exhaust work I've always wanted on my 92 245. I'll be replacing everything from the header connection back with 2.25 or 2.5 inch aluminized tubing, a free flow catalytic and a racing muffler (probably powerflow). Finding a replacement catalytic has been a little tough as most free flow models don't have the mounting for an oxygen sensor.

Has anyone here moved their oxygen sensor to the connection on the header? I replaced my old header with one from a wrecked 740 and it appears to have a fitting for a sensor already installed (plugged). My sensor is a three wire sensor, so I'm guessing that the integral heater would make it a little less sensitive for mounting?

Thanks everyone, hoping to squeeze a few more ponies out of my swedish iron.

Bob Mohr

1992 245 B230F





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Can I Move My Oxygen Sensor? [200][1992]
posted by  someone claiming to be Bob Mohr  on Sat Nov 6 15:54 CST 1999 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.