Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Don Foster, I'm about to do a clutch job 200 1992

posted by  someone claiming to be Stu on  Thu Aug 9 05:33 CST 2001 [RELATED]

...and I thought you might be able to give some good advice. I just searched the Brick archives for detail-rich how-to postings on replacing the pressure plate, disk and release bearing in a '92 240 with an M47 tranny, without luck.

Also, while I'm down there, I figure I'd replace the rear main cam seal and pilot bearing. And heeding your advice of a couple years back, I plan on installing a rear cam seal retainer.

Stu Craig

Middletown, RI

sbcraig@hotmail.com





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Don Foster, I'm about to do a clutch job [200][1992]
posted by  someone claiming to be Stu  on Thu Aug 9 05:33 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.