Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2001 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Crank shaft pulley removal HELP!! 700 1988

posted by  someone claiming to be Steve D on  Sat Sep 1 05:37 CST 2001 [RELATED]

As recommended in the FAQ I purchased the crank shaft pulley removal tool and it made the job of removing the center bolt very simple. Now that I have the bolt out the pulley doen't want to cooperate. I don't see any bolt holes to screw in a pulley remover so I am assuming that it is just frozen on the shaft. Does anyone have any ideas for getting the pulley off of the shaft? I can't seem to get a good angle behind it to whack it with a hammer and am at a loss. I have used penetrating oil to try and free it up with no affect. Any help you could offer would be greatly appreciated.

Thanks.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Crank shaft pulley removal HELP!! [700][1988]
posted by  someone claiming to be Steve D  on Sat Sep 1 05:37 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.